Question No : 1
On all the drives, which reserved region stores configuration information? (Choose the best answer.)

• A.Volume header
• B.Partition table
• C.Disk label
• D.DACstore
• E.NVSRAM

Show Answers

Answer:

Question No : 2
Identify this image.

• A.DE5612 ESM
• B.E5600 controller
• C.DE6600 ESM
• D.E2700 controller

Show Answers

Answer:

Question No : 3
What is the proper order to power-on E-Series arrays when a storage system has at least 2 trays? (Choose the best answer.)

• A.Power all expansion drive trays first, wait several minutes for the expansion drive trays to spin up, and then power on the controller drive tray
• B.Power on in any order, since the order does not matter
• C.Power up A-side power supplies first, then power up all B-side power supplies.
• D.Power on the controller drive tray first, then wait several minutes for the controller drive tray to spin up, and then power on all expansion drive trays

Show Answers

Answer:

Question No : 4
With ALUA support, how does the storage system handle I/Os to the non-preferred path? (Choose the best answer.)

• A.The controller handles them normally, updating both controllers’ cache to maintain consistency, which is why ALUA requires cache mirroring to be enabled.
• B.They are accepted but maintained in cache with a special change log, and only processed after 5 minutes when volume ownership may be changed.
• C.They are shipped over to the owning controller to be managed, then returned through the non-preferred path after completion.
• D.They are rejected with a specific SCSI check condition.
• E.The non-owning controller takes ownership of the volume in order to handle them, then restores ownership to the original controller.

Show Answers

Answer:

Question No : 5
In the AMW, which tab provides access to Ethernet management port configuration and premium feature enablement? (Choose the best answer.)

• A.Storage & Copy Services
• B.Host Mappings
• C.Configuration
• D.Hardware
• E.Setup

Show Answers

Answer:

Question No : 6
What does the storage system use to preserve cache data in the event of a complete controller failure? (Choose the best answer.)

• A.Cache mirroring
• B.Flash read cache
• C.Pre-fetch caching
• D.Read caching
• E.Write caching

Show Answers

Answer:

Question No : 7
1.What would be the minimum configuration required to support a drawer-protected 20-drive DDP? (Choose the best answer.)

• A.An E2624 with four DE5600 Expansion Chassis, containing a total of 6, 1.6TB SSD and 96, 3T NL-SAS drives.
• B.An E5460 with one DE6600 Expansion Chassis, containing a total of 120, 3TB NL-SAS drives.
• C.An E2712 with one DE6600 Expansion Chassis, containing a total of 72, 3TB NL-SAS drives.
• D.An E5424 with one DE5600 Expansion Chassis, containing a total of 48, 900GB SAS drives.

Show Answers

Answer:

Question No : 8
A company is using the Federal Information Processing Standard (FIPS) on all volume groups. However, one volume group failed a security audit.
In this scenario what would cause a volume group to fail the security audit?

• A.An FDE drive was added as a spare in the volume group
• B.Data Assurance was changed to “disabled” for the volume group
• C.The Secure Erase operation was applied to the volume group disks
• D.Connectivity to the key server was interrupted

Show Answers

Answer:

Question No : 9
Review the diagram.



Is this cabling correct or incorrect, and why? (Choose the best answer.)

• A.The cabling is incorrect because each controller goes to only one stack of disk shelves
• B.The cabling is correct for the dual stack cabling method
• C.The cabling is incorrect because it uses the top-down bottom-up cabling method
• D.The cabling is incorrect because the controllers are cabled from the host port.

Show Answers

Answer:

Question No : 10
A company has just installed a NetApp EF600 storage array with an initial drive count of 12. A disk pool is created using all 12 disks. Benchmark testing now shows that system performance is far less than expected. Metrics show a very unbalanced use of the two PcIe busses and drives.
In this scenario, which action addresses this problem?

• A.Dynamically convert the volumes from RAID 10 to RAID 5.
• B.Adjust cache block sizes to 8k.
• C.Build two equally sized pools during disk pool creation.
• D.Insert six drives into the first 12 slots and six drives into the last 12 slots.

Show Answers

Answer: