Question No : 1
Exhibit.



You are provisioning Layer 2 circuits between sites CE1. CE2. andCE3
Referring to the exhibit, which statement is true?

• A.Two VLANs must be configured from PE1 to CE1.
• B.A point-to-multipoint LSP must be created between sites.
• C.Site PE1 must have a point-to-multipoint link configured towards the core
• D.Each site must have only one VLAN configured to the PE

Show Answers

Answer:

Question No : 2
Exhibit.



You are providing camer-of-carner VPN services for AS 100 and AS 200 You want to distribute MPLS labels between your PE routers and the AS 100 and AS 200 CE routers.
What must be enabled to accomplish this task?

• A.Use BGP with the labeled-unicast address family enabled
• B.Use RSVP with the tunnel-services parameter enabled
• C.Use BGP with the inet-vpn address family enabled
• D.Use RSVP with the lsp-set parameter enabled

Show Answers

Answer:

Question No : 3
Exhibit:



Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)

• A.This is a source-specific multicast stream.
• B.The multicast stream does not have an R
• C.The multicast stream has been configured with a backup path to allow for fast reroute.
• D.The shortest path to the source is through the RP E The multicast receiver is still using the RP to receive the stream.

Show Answers

Answer:

Question No : 4
Exhibit:



Referring to the exhibit, which path would traffic passing through R1 take to get.

• A.R1 -> R2 -> R4 -> R6
• B.R1 -> R2 -> R3 -> R6
• C.R1 -> R3 -> R5 -> R6
• D.R1 -> R3 -> R4 -> R6

Show Answers

Answer:

Question No : 5
Exhibit:



A network administrator is concerned about the number of LSAs that they are observing on the network.
What will reduce Type 7 LSAs advertised from R2 to the non-backbone routers shown in the exhibit?

• A.Configure no-summaries under protocols ospf3 on R2.
• B.Configure no-naaa-abr under protocols ospf3 on R2.
• C.Configure no-summaries under area 0.0.0.2 on R2.
• D.Configure nssa under area 0.0.0.2 on R2.

Show Answers

Answer:

Question No : 6
Exhibit: Referring to the exhibit, you want to make ISP1 your preferred connection for inbound and outbound traffic.



Which two steps will accomplish this task? (Choose two.)

• A.Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R1.
• B.Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R1.
• C.Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R2.
• D.Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R2.

Show Answers

Answer: