Practice Free HP HPE0-S60 Exam Questions Online, HPE0-S60 Free Demo

Question 1 Selectable Answer

Which statement about HPE Apollo 2000 Gen10 Plus platform is true?

A. It is equipped with HPE Persistent memory by default
B. It can support a single processor only and up to 4 per chassis
C. It is fully managed using HPE OneView including all connections
D. It offers servers with AMD EPYC and Intel Xeon Scalable CPUs

Answer:

Question 2 Selectable Answer

What is a restriction of using a RoCE network?

A. It is by default configured as an untagged network and cannot be a part of a network set.
B. It does not support Private VLAN and Multicast VLA
C. it is not supported with HPE Virtual Connect SE 40 GD F8 Module for HPE Synergy.
D. It does not support smart link and private network features.

Answer:

Question 3 Written Answer

DRAG DROP
Put the steps of the HPE infosight flow in the correct order.

Answer:

Explanation:
(observing, learning, predicting, recommending, acting)

Question 4 Selectable Answer

Which statement about manual orchestration during the firmware update is true?

A. It is supported only for logical enclosures with at least three frames
B. It provides an ability to select and update one side of the Interconnect topology at a time
C. It provides the ability to install an older firmware version than currently Installed In the interconnect
D. It allows all the interconnect modules to be activated manually at the same time.

Answer:

Question 5 Written Answer

DRAG DROP
After HPE Superdome Flex deployment and nPar setup, you need to verify health status of HPE Superdome Flex components.
Put the steps on the left into the coned order on the right to perform this task.

Answer:

Question 6 Selectable Answer

As a result of the troubleshooting process, you recommend replacing, HPE Synergy Composer modules which HPE Synergy Composer 2
Why would you recommend this change?

A. HPE Composer 1 running HPE OneView 5 2 or later can support only 12 frames within a single management nog
B. HPE Composer 2 can support more than the maximum 21 frames that are supported with HPE Composer 1 and HPE OneView.
C. HPE Composer 2 provides access to 105 interface that can be used for full management of HPE Composer 2 remotely
D. HPE Composer 1 cannot support remote frames, which doubles the configuration and management procedures effort

Answer:

Question 7 Selectable Answer

Your customer plans to deploy ESXi systems to HPE Synergy and HPE ProLiant servers using HPE OneView for VMware vCenter Server.
Which statement about HPE OneView for VMware vCenter Server functionality is true for this environment?

A. HPE ProLiant servers need an HPE OneView for VMware vCenter Server license for full functionality
B. Individual systems can be added to HPE OneView for VMware vCenter Server through an ILO management processor
C. HPE Synergy requires HPE Composer 2 for full functionality of HPE OneView for VMware vCenter Server
D. Only systems managed using HPE Oneview can use HPE Oneview for VMware vCenter Server functionalities

Answer:

Question 8 Written Answer

DRAG DROP
Match HPE Superdome Flex system with its specific feature.

Answer:

Explanation:
HPE Superdome flex in all 4

Question 9 Written Answer

HOTSPOT
An HPE Synergy customer needs to prevent a timeout and loss of communication during an external switch firmware upgrade.
Click the parameter that the customer should configure within an uplink set to meet this requirement

Answer:

Question 10 Selectable Answer

Your customer has a logical enclosure configured using a angle HPE Synergy frame with the following configuration
- two HPE Virtual Connect SE 100Gb F32 Modules for Synergy
- two HPE Synergy Virtual Connect SE 32Gb FC Modules -12 HPE Synergy 480 Gen10 Plus compute nodes with appropriate mezzanine cards
They plan to add a new HPE Synergy frame to an existing logical enclosure with the following configuration
- two HPE Synergy Virtual Connect SE 32Gb FC Modules
- two HPE Synergy 20Gb interconnect Link Modules
- Eight HPE Synergy 480 Gen 10 Plus compute nodes with appropriate mezzanine cards.
Which statement about the planned configuration change is true?

A. Four compute modules must be moved to the second frame to balance the configuration
B. The two HPE Synergy 20Gb interconnect Link Modules must be replace with the 50Gb option
C. A license for an extended logical enclosure must be added to HPE OneView through GUI
D. The HPE Synergy virtual Connect SE 32Gb FC Modules from both frames should be stacked

Answer:

Question 11 Selectable Answer

Your customer reports that they cannot deploy HPE Synergy compute nodes using HPE OneView for VMware vCenter Server (HPE OV4VC).
What should you check during troubleshooting process?

A. If HPE OneView credentials are added in vCenter Server
B. If an compute nodes are added to the vCenter Server
C. If the HPE Oneview instance Is integrated with HPE OV4V
D. If vCenter Server is licensed in the HPE Oneview interface

Answer:

Question 12 Selectable Answer

A logical interconnect group can span on multiple HPE Synergy frames for which interconnect type?

A. Brocade 32GB Fibre Channel Switch Module for HPE Synergy
B. HPE virtual Connect SE 32 Gb FC Module for Synergy
C. HPE Virtual Connect SE 100 Gb F32 Module tor Synergy
D. HPE Synergy 12 Gb SAS Connection Module

Answer:

Question 13 Selectable Answer

Refer to the exhibit.

Which statement about this logical JBOD is true?

A. This logical JBOD can be connected to multiple systems to formulate a snared datastore.
B. After deleting this logical JBOD drives will he blocked for 12h m case this JBOD must be re-created
C. After deleting this logical JBOD, its drives w not be available until a clean-up procedure 6 done
D. This logical JBOD can be presented to the compute nodes in a different frame.

Answer:

Question 14 Selectable Answer

Which statement about the SY480 Gen10 Plus Compute Module is true?

A. It cannot be mixed with Gen9 compute modules in the same frame.
B. It supports 8 memory channels and memory DIMMs of up to 256G
C. It only supports NVDIMM Persistent Memory.
D. It supports "3rd Gen AMO EPYC Server Processors with 64 cores.

Answer:

Question 15 Selectable Answer

Your customer has the following HPE Synergy setup
- 3 HPE Synergy 12000 Frames
- 4 HPE Virtual Connect SE 100 Gb F32 Modules
- 2 HPE Synergy 50 GO Interconnect Link Modules
- 36 HPE Synergy 480 Gen10 Plus compute modules
- 2 HPE Composer 2 modules
Which statement about this setup is true?

A. To use all compute nodes, the customer must create at least two logical enclosures
B. To manage all frames, the customer must buy two additional HPE Composer 2 modules
C. The customer must buy 36 HPE OneView Advanced licenses to manage compute modules
D. The customer can add one D3940 storage Module to each of the frames

Answer:

Test Online Free HP HPE0-S60 Exam Questions and Answers