Question No : 1
In the past a customer experienced a networking issue where network ports went down and came back up in quick succession.
Which HPE Virtual Connect SE 100 GD F32 Module for HPE Synergy feature can be configured to disable such ports?

• A.Pause flood protection
• B.sFlow
• C.Storm control
• D.Port flap protection

Show Answers

Answer:

Question No : 2
Which compute node parameters are captured within server hardware type?

• A.Number of the CPUs
• B.installed operating system
• C.Mezzanine card configuration
• D.Size of the memory Installed

Show Answers

Answer:

Question No : 3
DRAG DROP
You need to setup HPE Synergy frames after hardware components are discovered within HPE OneView.
Put the steps to achieve this goal into the coned order in the answer area on the right.

Show Answers

Answer:

Question No : 4
HOTSPOT
Click the area within the iLO management interface that will allow you to access workload Advisor.

Show Answers

Answer:

Question No : 5
Which tool can be used to evaluate me health of an HPE Oneview appliance before proceeding with an appliance updated.

• A.HPE Composer Maintenance Console
• B.HPE OneView Update Readiness Checker
• C.HPE OneView Global Dashboard
• D.HPE OneView Firmware Compliance Report

Show Answers

Answer:

Question No : 6
HOTSPOT
Click the option that will allow you to change the ESXI image used In an OS Deployment Plan.

Show Answers

Answer:

Question No : 7
DRAG DROP
Match each HPE OneView network type with its definition.

Show Answers

Answer:

Question No : 8
You plan to configure a Link Aggregation Group (LAG) for two connections within a server profile for a compute node running an ESXI system.
What is required from the VMware side to enable LAG?

• A.Virtual Distributed Switch
• B.vSphere Standard license
• C.Load balancing cluster
• D.Dedicated VMKernel port

Show Answers

Answer:

Question No : 9
Refer to the exhibit.



Which statement about this logical interconnect group is true?

• A.Both modules are located in different frames for redundancy
• B.For an uplink set, ports from different modules can be selected
• C.interconnect modules are installed in interconnect bays 1 and 4
• D.An additional license is required to change the enclosure count

Show Answers

Answer:

Question No : 10
Which statement about an HPE Oneview support dump is true?

• A.Appliance support dump by default contains a logical enclosure support dump
• B.Support dump is a binary file that can be opened only in a dedicated application
• C.Support dump can be created if HPE Virtual Connect modules are installed in the frame
• D.Preview support dump is available only when creating an appliance support dump

Show Answers

Answer: