Test Online Free Cisco 350-601 Exam Questions and Answers
Practice a live sample before buying full access. This page keeps the free 350-601 question set organized by page so visitors and search engines can reach the canonical -questions.html URL directly.
An engineer implements a Cisco UCS C-Series Server that must adhere to these security requirements:
✑ Unencrypted communication must be disabled.
✑ The session timeout must not exceed 15 minutes.
✑ Unencrypted traffic must be automatically diverted.
✑ CLI-based management must use nondefault ports.
Which configuration set meets these requirements?
Answer:
Question 122Written Answer
What are two capabilities of the Cisco Network Assurance Engine? (Choose two.)
A. It verifies the speed of network packet flows by using telemetry.
B. It predicts the network load on a data center.
C. It validates that devices comply with network security policies.
D. It ensures that network performance meets an SLA.
E. It predicts the impact of changes to the network.
Answer: C,E Explanation:
- Predict the impact of network changes
- Verify network-wide behavior
- Ensure network security policy and compliance
https://www.cisco.com/c/en/us/products/collateral/data-center-analytics/network-assurance-engine/at-a-glance-c45-740230.html
Question 123Selectable Answer
The Cisco Nexus 5600 Series Switch experiences occasional packet drops on interface ethernet 1/16. An engineer wants to implement a SPAN session to investigate the issue further. The network analyzer to which the packets must be directed is located on interface 1/3. The analyzer is limited on disk space available for traffic capture, so the Nexus switch should send only the relevant data.
Which two command sets configure the SPAN session that meets these requirements? (Choose two.)
Answer: Explanation:
https://www.cisco.com/c/en/us/products/collateral/switches/nexus-5000-series-switches/white-paper-c11-733022.html
The information to be sent is regarding dropped packets only.
Question 124Selectable Answer
A network architect considers a Cisco HyperFlex design solution for a company. The proposed solution is for a virtual environment that is not performance-sensitive, but the solution must have high storage capacity and a low cost.
Which Cisco HyperFlex storage configuration should be used?
Answer: Explanation:
https://www.cisco.com/c/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/white-paper-c11-744026.html Hybrid contains HDD for capacity.
Question 125Selectable Answer
An engineer must allow communication between the APIC controller and an OpenStack OpFlex agent. The agent is running on a compute node directly plugged to a Cisco ACI leaf switch. The engineer must enable and extend Infra VLAN on the port facing the compute and extend the Infra VLAN to the host.
Which action must be taken to meet these requirements?
Answer:
Question 126Selectable Answer
Refer to the exhibit.
SVR-A in EPG-A/BD-A fails to reach SVR-B in EPG-B/BD-B.
Which two conditions should be verified to analyze the traffic between the two EPGs? (Choose two.)
Answer:
Question 127Selectable Answer
An engineer is configuring a vHBA template in Cisco UCS Manager. The engineer needs to specify the logical addresses used by the vHBA and the path through which the SAU Traffic flows.
Which two resources must be specified in the vHBA template? (Choose two)
Answer:
Question 128Selectable Answer
Which two protocols are used by the NFSv4 protocol? (Choose two.)
Answer:
Question 129Selectable Answer
Refer to the exhibit.
An engineer is configuring a VSAN on the network.
Which option must be selected to create the VSAN?
A network administrator is using the Cisco ESA with Cisco AMP to upload files to the cloud for analysis. The network is congested and is affecting communication.
How will the Cisco ESA handle any files which need analysis?
Answer:
Question 131Selectable Answer
What is the benefit of adding Cisco HyperFlex Hardware Acceleration Cards to a HyperFlex deployment?
Copy startup-config in the boot flash to the running-config file.
Answer: B Explanation:
TFTP runs on UDP 69 = Is correct
Question 133Selectable Answer
Refer to the exhibit.
An engineer needs to implement streaming telemetry on a cisco MDS 9000 series switch. The requirement is for the show command data to be collected every 30 seconds and sent to receivers.
Which command must be added to the configuration meet this requirement?
Answer: Explanation:
snsr-grp <id> sample-interval <interval> Currently, sensor group ID supports only numeric ID values. Specify the streaming sample interval value; the value must be in milliseconds. The minimum streaming sample interval that is supported is 30000 milliseconds. https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/8_x/config/san_analytics/cisco-mds9000-san-analytics-telemetry-streaming-config-guide-8x/configuring-san-telemetry-streaming.html
Question 134Selectable Answer
The FCoE technology is used in a data center and the MDS switches are configured as Fibre Channel Forwarders.
What configuration should be applied to an MDS switch in order to be used as the best switch to connect by the CNAs in the fabric?
An engineer has a primary fabric that is named UCS-A and a secondary fabric that is named UCS-B. A certificate request that has a subject name of sjc2016 for a keyring that is named kr2016 needs to be created. The cluster IP address is 10.68.68.68.
Which command set creates this certificate request?
