Question No : 1
Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

• A.On Orchestrator: Change QSFP mode from 100Gbps to 40Gbps
• B.On Orchestrator: Change port type from uplink to downlink
• C.On Appliance: Change a port speed to 10Gbps
• D.No change required

Show Answers

Answer:

Question No : 2
When running ifconfig command on an Appliance, there are interfaces shown in the list:
ethl-Sync and eth2-Sync.
What is the purpose of these interfaces?

• A.These interfaces are bond members (slaves) of Sync Bond
• B.These interfaces can be used as backup for Sync interface
• C.These interfaces are not in use. Security GW module use Sync interface for synchronization
• D.These interfaces represent physical Sync interface at the front panel of appliance

Show Answers

Answer:

Question No : 3
There's a 23800 appliance with quad NIC in slot 5.
What would be the name of port 3 on this NIC?

• A.ethBP3-05
• B.ethsBP5-03
• C.ethsBP3-05
• D.ethsBP-05

Show Answers

Answer:

Question No : 4
Which file on Appliance includes information about Security Group?

• A./etc/chassisdb.json
• B./etc/sgdb.json
• C./etc/smodb.json
• D./etc/distutiljson

Show Answers

Answer:

Question No : 5
What cannot be learned from the output ofasg monitorcommand?

• A.Appliances cluster status
• B.Port status
• C.Uptime
• D.Security Policy status

Show Answers

Answer:

Question No : 6
Which licenses should be issued for the Orchestrator?

• A.No licenses are required for Orchestrator
• B.The Orchestrator is considered a Management server, hence it's licensed the same way
• C.The Orchestrator requires NGTX license
• D.Depends on Software Blades enabled on connected appliances

Show Answers

Answer:

Question No : 7
Where shouldsx_api_ports_dump,pycommand be ran?

• A.Orchestrator
• B.SMO Appliance
• C.Management server
• D.Security Group

Show Answers

Answer:

Question No : 8
There is a Security group of 10 Appliances and all of them are up and running.
How many Appliances within a Security Group keep the same connection in its connection table in case of NAT?

• A.Between 2 and 4
• B.3
• C.All 10
• D.2

Show Answers

Answer:

Question No : 9
Complete the sentence: Orchestrators works as...

• A.Active-Active cluster
• B.Hot-Swap RAID
• C.Active-Standby cluster
• D.Load Sharing cluster

Show Answers

Answer:

Question No : 10
What is the default range of physical ports for downlinks on Orchestrator MHO-140?

• A.25 - 47
• B.27 - 47
• C.1 - 48
• D.1 - 25

Show Answers

Answer: